series g fully illuminated ultra-miniature toggles www.nkk.com a38 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable rockers touch tilt a toggles general specifcations electrical capacity (resistive load) logic level: 0.4va maximum @ 28v ac/dc maximum (applicable range 0.1ma ~ 0.1a @ 20mv ~ 28v) note: find additional explanation of operating range in supplement section. other ratings contact resistance: 80 milliohms maximum insulation resistance: 500 megohms minimum @ 500v dc dielectric strength: 500v ac minimum for 1 minute minimum mechanical life: 100,000 operations minimum electrical life: 100,000 operations minimum 10,000 operations minimum @ 0.1a @ 28v ac/dc nominal operating force: 1.30n angle of throw: 28 materials & finishes actuator: polyamide case: glass fber reinforced polyamide sealing rings: nitrile butadiene rubber movable contacts: phosphor bronze with gold plating stationary contacts: phosphor bronze with gold plating base: glass fber reinforced polyamide power terminals: phosphor bronze with gold plating lamp terminals: phosphor bronze with gold plating environmental data operating temperature range: C25c through +55c (C13f through +131f) humidity: 90 ~ 95% humidity for 240 hours @ 40c (104f) vibration: 10 ~ 500hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours shock: 50g (490m/s 2 ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) pcb processing soldering: wave soldering recommended. see profle a in supplement section. manual soldering: see profle a in supplement section. cleaning: automated cleaning. see cleaning specifcations in supplement section. standards & certifications the g series toggles have not been tested for ul recognition or csa certifcation. these switches are designed for use in a low-voltage, low-current, logic-level circuit. when used as intended in a logic-level circuit, the results do not produce hazardous energy.
series g fully illuminated ultra-miniature toggles www.nkk.com a39 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable a toggles rockers touch tilt distinctive characteristics actual size fully illuminated toggle for highly visible status indication with led in red, green, or amber for single color and red/green for bicolor. ultra-miniature size allows high density mounting, and extremely light weight makes these switches ideal for handheld equipment. totally sealed body construction prevents contact contamination and allows time- and money-saving automated soldering and cleaning. molded-in, epoxy sealed terminals lock out fux, solvents, and other contaminants. award-winning stc contact mechanism with benefts unavailable in conventional mech- anisms: smooth, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (additional stc details in terms & acronyms; see supplement section.) .100 x .100 (2.54mm x 2.54mm) terminal spacing conforms to standard pc board grid spacing. round terminals facilitate easier through- hole mounting on pc boards.
series g fully illuminated ultra-miniature toggles www.nkk.com a40 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable rockers touch tilt a toggles pole 1 spdt typical switch ordering example 1 g circuits 2 on none on combines with single color or bicolor leds 3 on off on combines with bicolor led only 2 description for typical ordering example g12jhc j h actuator j clear pc terminals p straight h right angle v vertical actuator j clear toggle c leds single color c red d amber f green on-none-on only bicolor cf red/green on-none-on & on-off-on 28 (1.7) dia .067 (4.0) dia .157 (3.8) .150 clear toggle, red led right angle pc terminals spdt on-none-on circuit toggle position connected terminals schematics pole throw model up center down up center down spdt g12 g13 on on none off on on 2-3 2-3 none open 2-1 2-1 poles & circuits slot slot note: terminal numbers are not actually on the switch. led circuit is isolated and requires an external power source. single color bicolor (5) (6) (5) (4) red (6) green led colors & specifications leds are an integral part of the switch and not available separately. the electrical specifcations shown are determined at a basic temperature of 25c. if the source voltage exceeds the rated voltage, a ballast resistor is required. the resistor value can be calculated by using the formula in the supplement; see supplement index. single color bicolor red amber green red/green forward peak current i fm 25ma 25ma 25ma 25ma/25ma typical forward current i f 20ma 20ma 20ma 20ma/20ma forward voltage v f 2.0v 2.1v 2.1v 2.0v/2.1v reverse peak voltage v rm 4v 4v 4v 4v/4v current reduction rate above 25c ?i f 0.33ma/c ambient temperature range C25 ~ +55c d f c cf colors 2 (com) 1 3
series g fully illuminated ultra-miniature toggles www.nkk.com a41 indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable a toggles rockers touch tilt pc terminals p h v straight right angle typical switch dimensions straight pc right angle pc 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. g12jpc 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. g12jhd vertical pc 5 & 6 are led terminals; 4 is a support pin on single color models & an led terminal on bicolor models. g12jvcf vertical (2.54) ty p .100 (2.6) .102 (2.54) ty p .100 (0.4) dia ty p .016 (7.0) .276 (4.5) .177 (0.4) dia ty p .016 (2.54) ty p .100 (7.0) .276 (4.5) .177 (2.54) ty p .100 (0.5) ty p .020 (4.5) .177 (7.0) .276 (0.5) ty p .020 (2.54) ty p .100 (2.54) ty p .100 (0.4) dia ty p .016 slot (4.5) .177 28 (1.7) dia .067 (4.0) dia .157 (0.4) dia ty p .016 (3.8) .150 (2.6) .102 (7.0) .276 (1.6) .063 (2.54) ty p .100 4 5 6 1 2 3 (7.0) .276 (2.54) .100 (0.6) dia ty p .024 (2.54) ty p .100 (2.54) .100 1 2 3 4 5 6 (0.6) dia ty p .024 (2.54) ty p .100 (2.54) .100 12 3 45 6 (5.08) .200 (0.6) dia ty p .024 (5.08) .200 (2.54) ty p .100 (2.54) .100 1 2 3 4 5 6 slot (5.08) .200 (7.8) .307 (0.4) dia ty p .016 (1.7) dia .067 (4.0) dia .157 (2.6) .102 (0.5) .020 (2.54) .100 (5.08) .200 (1.6) .063 (10.22) .402 (3.8) .150 28 32 1 4 5 6 (0.4) .016 (4.9) .193 (0.4) dia ty p .016 (7.0) .276 (2.54) ty p .100 (5.3) .209 (2.54) .100 (0.4) dia ty p .016 slot (2.6) .102 (0.5) ty p .020 (2.54) ty p .100 (1.6) .063 (3.8) .150 (1.0) .039 (5.08) .200 (12.76) .502 28 (1.7) dia .067 (4.0) dia .157 4 5 6 1 2 3 (7.4) .292 (2.54) .100 (4.5) .177 (0.4) dia ty p .016 (0.4) .016
|
